RDF System Management Manual

Entering RDFCOM Commands
HP NonStop RDF System Management Manual—524388-003
8-51
Command Overview
OUT
The OUT command redirects the output of the current RDFCOM session to the
specified device or file.
system
identifies the system on which the output file is stored.
volume
identifies the disk volume on which the output file is stored.
subvolume
identifies the subvolume on which the output file is stored.
file
specifies the name of the file or device to which RDFCOM is to direct subsequent
output.
If you enter the OUT command but omit the file identifier altogether, RDFCOM directs
the session output to the output file or device originally used for the current session.
Where Issued
Primary or backup system.
Security Restrictions
None; anyone can enter the OUT command.
RDF State Requirement
You can enter the OUT command at any time, whether or not RDF has been started.
Usage Guidelines
The OUT command specifies a file to which all subsequent output, other than prompts
for entering RDFCOM commands, is to be written during this session. This file will
receive listings produced by INFO, SHOW, and STATUS commands. The OUT
command is often used to establish the destination command file for the OBEYFORM
option of the INFO command.
If the specified output file does not exist, RDFCOM creates an EDIT (file code 101) file
with the designated name and redirects session output to that file. If you specify a disk
OUT [\system.][$volume.][subvolume.][file]