RDF System Management Manual

Entering RDFCOM Commands
HP NonStop RDF System Management Manual—524388-003
8-52
Command Overview
file that already exists, this must be an EDIT file; RDFCOM appends its output to that
file.
RDFCOM continues to direct session output to the designated file or device until you
issue another OUT command or until you terminate the session, whichever happens
first.
If you do not specify an OUT command in your session, RDFCOM directs output to the
current default output destination—usually the terminal from which you issued the
RDFCOM command to start the session.
Examples
Suppose that RDFCOM output is currently directed to the terminal at which you are
entering commands. To temporarily direct an RDF status display to a specific spooler
location and then redirect all subsequent session output back to your terminal, enter
the following commands:
]OUT $s.#lp
]STATUS RDF
]OUT
The next OUT command establishes the destination of the text produced by the
OBEYFORM option in the subsequent INFO RDF command as a command file named
CONFY. The second OUT command in this sequence redirects later output back to
your terminal:
]OUT CONFY
]INFO RDF, OBEYFORM
]OUT