RDF System Management Manual

Entering RDFCOM Commands
HP NonStop RDF System Management Manual—524388-003
8-74
Command Overview
SET RECEIVER
The SET RECEIVER command sets receiver process configuration parameters within
the RDF configuration memory table. The supplied values are not applied to the RDF
configuration file, however, until you issue an ADD RECEIVER command.
ATINDEX audittrail-index-number
is an integer value identifying a configured TMF audit trail on the primary system. 0
specifies the MAT. 1 through 15 specify auxiliary audit trails AUX01 through
AUX15. The default is 0. For each configured extractor, there must be a
corresponding receiver with the same ATINDEX value.
For information about protecting auxiliary audit trails, see Section 12, Auxiliary
Audit Trails.
CPUS primary-CPU : backup-CPU
identifies the CPUs in which the receiver process is to run as a process pair on the
backup system; primary-CPU is the primary CPU; backup-CPU is the backup
CPU. Values range from 0 through 15. The default is 0:1.
EXTENTS ( primary-extent , secondary-extent )
specifies the extent sizes to be used for the RDF image files on the backup
system; primary-extent-size is the primary extent size in pages;
secondary-extent-size is the size of each secondary extent in pages. The
default is 100,100. The limit is 65500, 65500. This parameter only has an effect
when specified for the MAT receiver.
SET RECEIVER receiver-option
where receiver-option is:
{ATINDEX audittrail-index-number }
{CPUS primary-CPU : backup-CPU }
{EXTENTS (primary-extent , secondary-extent) }
{RDFVOLUME $volume }
{PRIORITY priority }
{PROCESS process-name }
{SLOWMODE {ON | OFF} }