RDF System Management Manual

Entering RDFCOM Commands
HP NonStop RDF System Management Manual—524388-003
8-78
Command Overview
SET TRIGGER
The SET TRIGGER command sets trigger parameters within the RDF configuration
memory table. The supplied values are not applied to the RDF configuration file,
however, until you issue an ADD TRIGGER command. The trigger type (REVERSE or
TAKEOVER) is specified in the ADD TRIGGER command.
program-file
is the name of any Guardian object file. This object file is run once RDF has
reached a particular state, either after a STOP RDF, REVERSE, or TAKEOVER
operation. program-file must be a properly-formed Guardian disk file name.
The file does not have to exist. This parameter is mandatory. Typically program-
file is $SYSTEM.SYSTEM.TACL if you want to run a TACL macro.
Alternatively, program-file could be RDFCOM if no TACL macro is required.
infile
is the name of an edit file that will be passed as the IN file to the trigger process
when it is created. infile must be a properly-formed Guardian disk file name.
The file does not have to exist. This parameter is mandatory.
outfile
is the name of a file or process that will be passed as the OUT file to the trigger
process when it is created. outfile must be a properly-formed Guardian disk
file or process name.
CPUS primary-CPU : alternate-CPU
are the numbers of the primary and alternate CPUs in which the trigger process is
to run. The alternate CPU is used only if the primary CPU is unavailable when the
trigger is started. Values range from 0 through 15. The defaults are 0:1.
priority
is the process priority of the trigger process. priority must be an integer from
10 through 199. The default is 150.
SET TRIGGER trigger-option
where trigger-option is:
{PROGRAM program-file }
{INFILE infile }
{OUTFILE outfile }
{CPUS primary-CPU : alternate-CPU }
{PRIORITY priority }
{WAIT |NOWAIT }