RDF System Management Manual

Entering RDFSCAN Commands
HP NonStop RDF System Management Manual—524388-003
9-2
Command Description Elements
Command Description Elements
The RDFSCAN command descriptions include the same elements as the RDFCOM
command descriptions appearing in Section 8, except for the following items, which are
not included because they are the same in all cases:
•
Where Issued: All RDFSCAN commands can be issued at either the primary or
backup node.
•
Security Restrictions: All RDFSCAN commands are unrestricted; they can be
entered by anyone who can log on to the node.
•
RDF State Requirement: All RDFSCAN commands can be entered at any time,
whether or nor RDF is initialized or running.
In addition, the following element is included only if applicable:
•
Output Displayed: Only two RDFSCAN commands (LIST and SCAN) produce
output, although others influence its content and destination.
For information about the other elements, see “Command Description Elements” in
Section 8.
Except for the LOG and NOLOG commands, you can abbreviate the command name
by entering only the first character (such as L for LIST) or any number of the leading
characters (such as DIS for DISPLAY). You can use either uppercase or lowercase
letters.
As in earlier sections, the boldface text in the examples represents characters you
enter in response to messages that prompt you for input.
Descriptions of all RDFSCAN commands follow in alphabetical order.