RDF System Management Manual

Network Transactions
HP NonStop RDF System Management Manual—524388-003
13-4
Network Configuration Record
PRIMARYSYSTEM Network Attribute
This is the name of a primary system. It is set by the following RDFCOM command:
SET NETWORK PRIMARYSYSTEM system-name
There is no default value. Each primary system within an RDF network must be
unique within the network. An RDF network cannot contain two or more RDF
subsystems with the same primary system (that is, it cannot contain RDF subsystems
for \A to \B and \A to \C).
BACKUPSYSTEM Network Attribute
This is the name of the backup system associated with the specified primary system. It
is set by the following RDFCOM command:
SET NETWORK BACKUPSYSTEM system-name
There is no default value.
REMOTECONTROLSUBVOL (RCSV) Network Attribute
The remote control subvolume (RCSV) is the name of the control subvolume used by
the RDF subsystem configured for the specified primary and backup systems. It is set
by the following RDFCOM command.
SET NETWORK REMOTECONTROLSUBVOL subvolume-name
There is no default value.
PNETTXVOLUME Network Attribute
You only use this attribute when configuring the network master. On the master you
must include this attribute within every network configuration record (including the one
for the master itself).
This attribute specifies the name of the volume on the particular primary system where
the RDF network master stores an audited network-synchronization file. The specified
volume must be a data volume protected by the RDF subsystem on the primary
system and be configured to the MAT. The PNETTXVOLUME volume is set by the
following RDFCOM command.
SET NETWORK PNETTXVOLUME volume-name
There is no default value.
Adding the Network Record
When you have finished setting the attributes for a given RDF subsystem, you add that
information to your current configuration file with the following RDFCOM command.
ADD NETWORK