RDF System Management Manual

RDF Command Summary
HP NonStop RDF System Management Manual—524388-003
A-6
OPEN
The OPEN command specifies the RDF control subvolume to which subsequent
commands in this RDFCOM session apply.
Where Issued: Primary or backup system.
Security: Any user.
OUT
The OUT command redirects the output of the current RDFCOM session to the
specified device or file.
Where Issued: Primary or backup system.
Security: Any user.
RESET
The RESET command resets all configuration parameters for the specified process to
their default values within the RDF configuration memory table. The corresponding
parameters within the configuration file do not change, however, unless you issue an
ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
OPEN control-subvolume
OUT [\system.][$volume.][subvolume.][file]
RESET {RDF }
{MONITOR }
{EXTRACTOR }
{RECEIVER }
{VOLUME }
{IMAGETRAIL }
{PURGER }
{RDFNET }
{NETWORK }
{TRIGGER }