RDF System Management Manual

RDF Command Summary
HP NonStop RDF System Management Manual—524388-003
A-10
SET RDF
The SET RDF command sets the designated RDF global configuration parameters to
the supplied values within the RDF configuration memory table. The supplied values
are not applied to the RDF configuration file, however, until you issue an
ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
SET RDFNET
The SET RDFNET command sets the designated configuration parameters for the
RDFNET process to the supplied values within the RDF configuration memory table.
The supplied values are not applied to the RDF configuration file, however, until you
issue an ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
SET RDF global-option
where global-option is:
{LOGFILE $ems-collector-name }
{UPDATERDELAY delay-time }
{UPDATERTXTIME tx-time }
{UPDATERRTDWARNING rtd-time }
{UPDATEROPEN {PROTECTED | SHARED} }
{SOFTWARELOC $volume.subvolume }
{NETWORK {ON | OFF} }
{NETWORKMASTER {ON | OFF} }
{UPDATEREXCEPTION {ON | OFF} }
{LOCKSTEPVOL $volume }
{REPLICATEPURGE {ON | OFF} }
{REMOTE MIRROR {ON | OFF} }
{REMOTE STANDBY {node-name} }
{OWNER {owner-id} }
SET RDFNET netsync-option
where netsync-option is:
{CPUS primary-CPU : backup-CPU}
{PRIORITY priority-number }
{PROCESS process-name }