RDF System Management Manual

Messages
HP NonStop RDF System Management Manual—524388-003
C-8
RDF Messages
Recovery. Consult the description of the NEWPROCESS procedure in the Guardian
Procedure Errors and Messages Manual to determine the cause of the failure. Once
the underlying cause is corrected, the backup process can be created.
714
error
is the file-system error number that identifies the specific error.
Cause. A call to the checkpoint procedure failed, and the backup process of a
NonStop process pair is still running. The message includes the number of the file-
system error that was encountered when the primary process was trying to
communicate with the backup process.
Effect. The backup process is stopped, and a new one is created after about
15 seconds.
Recovery. Consult the description of the CHECKPOINT procedure in the Guardian
Procedure Calls Reference Manual to determine the cause of the failure. If possible,
correct the underlying cause to avoid its reoccurrence.
715
Cause. The primary process of a NonStop process pair has stopped. This probably
was the result of an operator inadvertently issuing a STOP command from TACL.
Effect. The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
Recovery. This is an informational message; no recovery is required.
716
Cause. The primary process of a NonStop process pair has abended.
Effect. The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
Recovery. Scan the EMS event log to determine why the process abended. An
INSPECT SAVEABEND file should have been created in the volume and subvolume
where you placed the RDF/IMP software; you should save that file for problem
resolution by your service provider.
CHECKPOINT Failure - backup comm error error
Primary stopped
Primary abended