RDF System Management Manual

Messages
HP NonStop RDF System Management Manual—524388-003
C-11
RDF Messages
723
filename
is the name of the audit-trail file that contained the error.
rba
is the relative byte address where the error occurred in the audit-trail file.
Cause. The extractor encountered an irrecoverable error at the designated relative
byte address (rba) in the designated TMF audit-trail file. This message indicates an
internal RDF or TMF error.
Effect. This is a catastrophic error; the extractor abends, and RDF stops.
Recovery. Because this message indicates a system error, you should preserve the
indicated audit-trail file for further analysis by your service provider.
724
Cause. The purger has determined that all updaters have processed through to the
end of the image trail and the RDF TAKEOVER operation has completed.
Effect. Normal purger shutdown processing continues. When the purger stops, the
TAKEOVER operation will be finished.
Recovery. This is an informational message; no recovery is required.
725
Cause. One of two conditions caused this event.
1. UPDATE was OFF when the purger began the RDF TAKEOVER operation.
2. At least one updater process terminated prematurely, without processing through
to the end of the image trail. The premature updater shutdown may have resulted
from a double CPU failure or a STOP command entered manually from TACL.
Because the updater might not have processed all image audit, the RDF
TAKEOVER operation cannot be considered complete. Scan the EMS event log
for RDF message 726: this message identifies the updater process that did not
complete TAKEOVER processing.
Effect. Normal purger shutdown processing continues.
Irrecoverable error on audit-trail file filename at RBA rba
RDF TAKEOVER has completed successfully
RDF TAKEOVER has not completed