RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-21
Command Overview
FC
The FC (fix command) command enables you to selectively examine, edit, or repeat a
previously issued RDFCOM command.
{FC} [ text ]
requests RDFCOM to display the most recently issued command that begins with
the specified text string and issue a period (.) prompt for your input. You can
then use the subcommands R, I, and D to replace, insert, and delete characters in the
command line. If you omit the text parameter, RDFCOM displays the most
recently issued command.
{?} [ text ]
requests RDFCOM to display the most recently issued command that begins with
the specified text string. If you omit the text parameter, RDFCOM displays
the most recently issued command.
{!} [ text ]
requests RDFCOM to execute the most recently issued command that begins with
the specified text string. If you omit the text parameter, RDFCOM executes
the most recently issued command.
Where Issued
Primary or backup system.
Security Restrictions
None; anyone can enter the FC command.
RDF State Requirement
You can enter the FC command at any time, whether or not RDF has been started.
Usage Guidelines
When you issue an FC command, the requested command appears, followed by a
subcommand prompt (.). At the prompt, you can enter the subcommands R, I, or D to
respectively replace, insert, or delete characters in the command line. As a simpler
alternative to the R subcommand, you can simply enter the replacement character
directly under the character you want to replace.
{FC} [text]
{? } [text]
{! } [text]