RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-35
Command Overview
Now, suppose you configured three updater processes (named $UP01, $UP02, and
$UP03) and that those processes are backing up the primary system volumes $DATA01,
$DATA02, and $DATA03, respectively, onto the volumes $DATA1, $DATA2, and
$DATA3 on the backup system. The updaters $UP01 and $UP02 are accessing the
secondary image trail $SECIT1; updater $UP03 is accessing the secondary image trail
$SECIT2.
To display the current configuration parameters for all of the updater processes, enter:
]INFO VOLUME *
RDF displays the following:
VOLUME ATINDEX 0
VOLUME $DATA01
VOLUME CPUS 0:1
VOLUME PRIORITY 160
VOLUME UPDATEVOLUME $DATA1
VOLUME IMAGEVOLUME $SECIT1
VOLUME PROCESS $UP01
VOLUME ATINDEX 0
VOLUME $DATA02
VOLUME CPUS 2:3
VOLUME PRIORITY 160
VOLUME UPDATEVOLUME $DATA2
VOLUME IMAGEVOLUME $SECIT1
VOLUME PROCESS $UP02
VOLUME ATINDEX 0
VOLUME $DATA03
VOLUME CPUS 4:5
VOLUME PRIORITY 160
VOLUME UPDATEVOLUME $DATA3
VOLUME IMAGEVOLUME $SECIT2
VOLUME PROCESS $UP03
INFO PURGER Command
To display the current configuration parameters for the purger process, enter the
following command:
]INFO PURGER
The output shows that the purger is configured with the following parameter values:
running in CPUs 3 and 2, with a priority of 165, with a retaincount of 50, and with a
process name assigned by the subsystem (and thus unlisted in the display):
PURGER CPUS 3:2
PURGER PRIORITY 165
PURGER RETAINCOUNT 50