RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-51
Command Overview
SET EXTRACTOR
The SET EXTRACTOR command sets extractor process configuration parameters
within the RDF configuration memory table. The supplied values are not applied to the
RDF configuration file, however, until you issue an ADD EXTRACTOR command.
CPUS primary-CPU : backup-CPU
identifies the CPUs in which the extractor process is to run as a process pair on the
primary system; primary-CPU is the primary CPU; backup-CPU is the
backup CPU. Values range from 0 through 15. The defaults are 0:1.
PRIORITY priority
identifies the execution priority for the extractor process; priority is the
execution priority, from 10 through 199. The default priority is 165.
PROCESS process-name
identifies the process name for the extractor process; process-name is any
unique, valid process name of up to 5 characters; the first character must be a dollar
sign ($). You cannot specify reserved process names of the form $Xddd, $Yddd,
or $Zaaa, in which d is any numeric character and a is any alphanumeric
character. Names longer than 5 characters, including the $ sign, are invalid.
If you omit this option, the operating system selects a name for the extractor
process.
SET EXTRACTOR extractor-option
where extractor-option is:
{CPUS primary-CPU : backup-CPU }
{CPUS 0 }
{PRIORITY priority }
{PROCESS process-name }
{RESET PROCESS }
{ATINDEX audittrail-index-number }
{RTDWARNING rtd-time }