RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-58
Command Overview
Usage Guidelines
The SET NETWORK command enters the RDF network parameter values specified in
this command into the RDF configuration table in memory. This table serves as an input
buffer only, and so these values do not affect the subsystem until they are applied to the
RDF configuration file with the ADD command.
Example
To configure the primary system \RDF04 and backup system \RDF06, issue the
following commands after RDF has been initialized:
SET NETWORK PRIMARYSYSTEM \RDF04
SET NETWORK BACKUPSYSTEM \RDF06
SET NETWORK REMOTECONTROLSUBVOLUME RDF04
SET NETWORK PNETTXVOLUME $DATA07
ADD NETWORK