RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-65
Command Overview
Security Restrictions
You can issue the SET RDF command only if you are a member of the super-user group.
RDF State Requirement
You can only enter the SET RDF command for global configuration parameters if you
have not already used the ADD RDF command to apply the parameter values to the
RDF configuration file. For further information, see the ADD command description.
Usage Guidelines
The SET RDF command enters the global parameter values specified in this command
into the RDF configuration table in memory. This table serves as an input buffer only,
and so these values do not affect the subsystem until they are applied to the RDF
configuration file with the ADD command.
Example
Suppose that $SWAP is the name of the RDF swap volume on both the primary and
backup systems. To use that configuration and set all other RDF global parameters to
their default values, issue the following commands after RDF has been initialized:
]SET RDF PRIMARYSWAP $SWAP
]SET RDF BACKUPSWAP $SWAP
]ADD RDF