RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-67
Command Overview
Usage Guidelines
The SET RDFNET command enters the parameter values specified for the RDFNET
process in this command into the RDF configuration table in memory. This table serves
as an input buffer only, and so these values do not affect the subsystem until they are
applied to the RDF configuration file with the ADD command.
Example
To configure a RDFNET process named $MNET to run in CPUs 0 and 1 at a priority of
180, issue the following commands after RDF has been initialized:
]SET RDFNET PROCESS $MNET
]SET RDFNET CPUS 0:1
]SET RDFNET PRIORITY 180
]ADD NETRDF