RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-72
Command Overview
SET VOLUME
The SET VOLUME command sets updater process configuration parameters within the
RDF configuration memory table. The supplied values are not applied to the RDF
configuration file, however, until you issue an ADD VOLUME command.
ATINDEX audittrail-index-number
is an integer value from 0 through 15 specifying the audit trail on the primary
system to which the data volume being protected is mapped. 0 specifies the MAT. 1
through 15 specifies auxiliary audit trails AUX01 through AUX15, respectively. The
default is 0.
CPUS primary-CPU : backup-CPU
identifies the CPUs in which the updater process is to run as a process pair on the
backup system; primary-CPU is the primary CPU; backup-CPU is the backup
CPU. Values range from 0 through 15. The defaults are 0:1.
PRIORITY priority
identifies the execution priority for the updater process; priority is the
execution priority, from 10 through 199. The default is 160.
PROCESS process-name
identifies the process name for the updater process; process-name is any
unique, valid process name of up to 5 characters; the first character must be a dollar
sign ($). You cannot specify reserved process names of the form $Xddd, $Yddd,
or $Zaaa, in which d is any numeric character and a is any alphanumeric
character. Names longer than 5 characters, including the $ sign, are invalid.
If you omit this option, the operating system selects a name for the updater process.
SET VOLUME volume-option
where volume-option is:
{ATINDEX audittrail-index-number }
{CPUS primary-CPU : backup-CPU }
{PRIORITY priority }
{PROCESS process-name }
{RESET PROCESS }
{SYNCH }
{IMAGEVOLUME $volume }
{UPDATEVOLUME $volume }
{INCLUDE subvol.file }
{EXCLUDE subvol.file }