RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual522204-001
8-77
Command Overview
Security Restrictions
None; anyone can issue the SHOW command.
RDF State Requirements
You can enter the SHOW command at any time.
Usage Guidelines
This command retrieves information from the RDF configuration memory table, which
serves as an input buffer for a subsequent ADD command.
If you have not yet issued any SET commands for the specified object, or have issued a
RESET command for it, the SHOW command displays the default option values for the
object.
If you want to see what parameter values are already set in the configuration file, use the
INFO command.
Output Displayed
The parameters displayed for the RDF global options and the individual processes are
explained under the SET EXTRACTOR, SET MONITOR, SET PURGER, SET RDF,
SET RECEIVER, and SET VOLUME command descriptions.
Examples
Examples of several SHOW commands follow:
SHOW RDF Command
Suppose that a series of SET RDF commands specifies the following configuration
parameter values:
$BIG is the swap volume on the backup system.
$SYSTEM is the swap volume on the primary system.
To display the global configuration parameter values specified by those SET RDF
commands, enter:
]SHOW RDF
In response, RDFCOM displays:
RDF SOFTWARELOC $SYSTEM.RDF
RDF BACKUPSWAP $BIG
RDF BACKUPSYSTEM \TORONTO
RDF CONTROL SUBVOLUME SANFRAN
RDF LOGDEVICE $0
RDF LOGFILE $0
RDF PRIMARYSWAP $SYSTEM