RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Entering RDFCOM Commands
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
8-92
Command Overview
STOP SYNCH
The STOP SYNCH command is used as part of the online database synchronization
protocol.
Where Issued
Primary system.
Security Restrictions
None; anyone can issue the STOP RDF command.
RDF State Requirement
You can issue the STOP RDF command only when RDF is running.
Usage Guidelines
You must wait until the preceding load or backup operations are done before issuing this
command.
See the descriptions of online database synchronization in Section 7, Online Database
Synchronization for the proper use of this command.
Example
To issue this command as part of online database synchronization, enter:
]STOP SYNCH
STOP SYNCH