Manualshelf

RDF/IMP and IMPX System Management Manual (RDF 1.3+)

ManualsBrandsHP ManualsServerHP NonStop G-Series
341342343344345346347348349350
Lockstep Operation
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
14-8
Lockstep Operation Event Messages
Lockstep Operation Event Messages
1
Cause. While reading $RECEIVE, the lockstep gateway received an I/O completion on
an unknown file number.
Effect. The lockstep gateway stops.
Recovery. This is an internal error, but the gateway is restarted. If the problem persists,
contact the Compaq Global Customer Support Center (GCSC) or your service provider.
2
Cause. You are missing either the ENABLE/DISABLE argument, or you have not
specified the name of the RDF extractor.
Effect. The lockstep gateway stops.
Recovery. In your SCF script for starting the lockstep gateway, you must specify either
ENABLE or DISABLE and the RDF extractor process name with the STARTUPMSG
attribute. Note that the process name must not include a node name.
3
Cause. You did not specify ENABLE or DISABLE as the first argument of the
STARTUPMSG attribute in your SCF script.
Effect. The lockstep gateway stops.
Recovery. In your SCF script for starting the lockstep gateway, you must specify either
ENABLE or DISABLE as the first argument of the STARTUPMSG attribute.
I/O completed on an unknown file number.
A STARTUPMSG argument is missing for the lockstep gateway.
The first argument of the STARTUPMSG attribute for your
lockstep gateway was neither ENABLE nor DISABLE.