RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-3
RDF Messages
702
program
is the name of the program file that RDF tried to execute.
expected
is the expected version number of the program.
received
is the actual version number of the program, as reflected by the program file.
Cause. In response to a START RDF command, RDF tried to execute the designated
program file ( program ). The program in that file, however, had a different version
number ( received ) than was expected ( expected ). You have installed the
wrong version of RDF.
Effect. RDF stops.
Recovery. Install the correct version of RDF on all nodes, and then enter the START
RDF command.
703
Cause. The updater has sent a request for permission to read the undo list, but the
purger has not yet given the updater permission.
Effect. The updater waits until the purger has completed building the undo list.
Recovery. This is an informational message; no recovery is required, unless the purger
is reporting problems.
704
Cause. The purger has detected that all the updaters have stopped, but at least one
updater stopped prematurely and did not stop at the specified timestamp.
Effect. The updaters are stopped, but the backup database is not in a consistent state
corresponding to the stop update timestamp.
Recovery. Restart the updaters. If you still need to bring the backup database to a
consistent state, wait for the updaters to catch up and then issue a new STOP UPDATE,
timestamp command, specifying a new timestamp.
Program version is inconsistent program expected received
Still waiting on purger for undo pass.
Stop update to time operation has not completed successfully.