RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-4
RDF Messages
705
error#
is the file-system error number that identifies the specific error.
name
is the name of the file or process that was to be opened.
Cause. A file-system error occurred while RDF was attempting to open a file or
process.
Effect. Variable; depends upon which file-system error occurred and which file or
process was to be opened. If this error is issued by a process other than an updater
against any file other than the EMS event log, then RDF will shut down, except in the
following cases:
•
The extractor retries OPEN calls for the audit trail files if file-system error 11
(file missing), 12 (file in use), or 59 (file is bad) occurs. Those errors might occur
while the audit trail file is being restored to disk. The extractor retries the OPEN
operation indefinitely, and will respond to RDFCOM commands while the retries
are taking place.
•
The receiver retries OPEN calls for the image files if file-system error 11 (file
missing), 12 (file in use), or 59 (file is bad) occurs. Those errors might occur while
the image file is being restored to disk.
Recovery. If this message is issued by an updater process, consult Table 5-1
to
determine the appropriate recovery actions.
706
Cause. The monitor process has stopped itself and all RDF processing as the result of
an operator-initiated stop or a catastrophic failure.
Effect. The monitor sends a stop message to all RDF processes, and they all
successfully shut down.
Recovery. If the operator issued a STOP TMF or STOP RDF command, this message is
merely informational and no recovery is required.
If this message is unexpected, check the EMS event log to determine the cause of the
failure.
File Open Error error# name
Note. If the extractor detects that the OPEN operation failed because the audit trail had
been purged, it logs RDF Error 839 (Audit trail file is missing) rather than Error 705,
prompting you to restore the audit trail file.
RDF Monitor Shutdown Complete