RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-8
RDF Messages
715
Cause. The primary process of a process pair has stopped. This probably was the result
of an operator inadvertently issuing a STOP command from TACL.
Effect. The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
Recovery. This is an informational message; no recovery is required.
716
Cause. The primary process of a process pair has abended.
Effect. The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
Recovery. Scan the EMS event log to determine why the process abended. An
INSPECT SAVEABEND file should have been created on $SYSTEM.RDF; you should
save that file for problem resolution by your service provider.
717
Cause. The primary CPU of a process pair has stopped.
Effect. The backup process takes over, but not in fault-tolerant mode. The primary
process will be re-created after its CPU is reloaded.
Recovery. Reload the downed processor.
718
Cause. The original backup process of a process pair has successfully created a backup
process in the configured primary processor and has successfully switched processing to
that process.
Effect. The process pair is switching primary and backup roles so that the primary
process is now running in the CPU configured as the primary processor.
Recovery. This is an informational message; no recovery is required.
Primary Stopped
Primary Abended
Primary Processor Down
Switched to original Primary Processor