RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-9
RDF Messages
719
nnn
is the status word returned by CHECKPOINT.
Cause. A CHECKPOINT call from the primary process of a process pair to its backup
process failed because of a parameter error. This message indicates a programming
problem within RDF. The message includes the status word returned by the
CHECKPOINT procedure.
Effect. The backup process is stopped, and a new one is created after about 15 seconds.
Recovery. This is an informational message; no recovery is required. You should,
however, contact your service provider and explain that this error occurred.
720
Cause. The extractor detected an error in block sequence numbers in the TMF Master
Audit Trail. The sequence numbers show that a single block is missing.
Effect. This is only a warning. Normal processing continues. It is possible, however,
that the backup database is no longer consistent with the primary database.
Recovery. This is an informational message; no recovery is required. Tell your
database administrator, however, that this error occurred. The database administrator
should consider checking the synchronization of the primary and backup databases, as
described in Section 6 of the manual.
721
Cause. The extractor detected an error in block sequence numbers in the TMF Master
Audit Trail. The sequence numbers show that multiple blocks are missing.
Effect. This is only a warning. Normal processing continues. It is possible, however,
that the backup database is no longer consistent with the primary database.
Recovery. This is an informational message; no recovery is required. Tell your
database administrator, however, that this error occurred. The database administrator
should consider checking the synchronization of the primary and backup databases, as
described in Section 6 of the manual.
Bad Parameter in CHECKPOINT - Status: nnn
Audit Trail Single Block Missing
Audit Trail Multiple Blocks Missing