RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-10
RDF Messages
722
sno
is the sequence number of the audit trail for which the extractor is waiting.
Cause. The extractor has requested that the specified audit trail file be restored from
tape.
Effect. The extractor waits until the audit trail file is restored.
Recovery. If you have already mounted the correct tape, then this is an informational
message. If you have not mounted the tape, check the EMS event log to see what tape
TMF requires, and mount that tape.
723
filename
is the name of the audit trail file that contained the error.
rba
is the relative byte address where the error occurred in the audit trail file.
Cause. The extractor encountered an irrecoverable error at the designated relative byte
address (rba) in the designated TMF audit trail file. This message indicates an internal
RDF or TMF error.
Effect. This is a catastrophic error; the extractor abends, and RDF stops.
Recovery. Because this message indicates an internal error, you should preserve the
indicated audit trail file for further analysis and then provide this file to your service
provider.
724
Cause. The receiver has determined that all updaters have processed through to the end
of the image trail and the RDF takeover operation has completed.
Effect. Normal receiver shutdown processing continues. When the receiver stops, the
takeover operation is finished.
Recovery. This is an informational message; no recovery is required.
Waiting for AuditTrail File Restoration: sno
Irrecoverable error on Audit Trail file filename rba
RDF TAKEOVER has completed successfully