RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-11
RDF Messages
725
Cause. The receiver has determined that at least one updater process terminated
prematurely, without processing through to the end of the image trail. The premature
updater shutdown may have resulted from a double CPU failure or a command entered
manually from TACL. Because the updater might not have processed all image audit,
the RDF takeover operation cannot be considered complete. Scan the EMS event log for
RDF message 726: this message identifies the updater process that did not complete
takeover processing.
Effect. Normal receiver shutdown processing continues.
Recovery. Restart the takeover operation by issuing an RDFCOM TAKEOVER
command.
726
vol -> vol
are the volume on the primary node that the updater is protecting and the
corresponding volume to which it is writing on the backup node.
Cause. The receiver has determined that the updater process indicated in this message
did not complete its RDF takeover processing. That updater may have stopped
prematurely because of a double CPU failure or a command entered manually from
TACL.
Effect. The updater responsible for the volume named in the message did not complete
RDF takeover processing.
Recovery. When you have determined why the updater stopped prematurely and have
corrected the problem, reissue the RDFCOM TAKEOVER command.
727
sno
is the sequence number of the missing audit trail file.
Cause. The specified file should exist on disk, but it does not.
Effect. The extractor abends.
Recovery. This is an internal error. Contact your service provider.
RDF TAKEOVER has not completed
Updater did not complete the TAKEOVER: <vol -> vol>
Audit Trail File Missing: sno