RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-14
RDF Messages
734
type
is the message number in the received message, which was not one of the codes
recognized by the RDF process.
Cause. An RDF process received a message that does not apply to it.
This message is a warning that indicates that a possible problem existed in the
configuration file, a programming problem occurred within RDF, or a process outside of
RDF tried to communicate with an RDF process.
Effect. The message type is reported with no other effect.
Recovery. This is an informational message; no recovery is required. To see if the
message resulted from an incorrect configuration file, examine the configuration file and
verify that all necessary parameters have been specified correctly. Report this error to
your service provider.
735
sno
is the sequence number in the Master Audit Trail (MAT) of the last audit record
received by the RDF receiver process.
rba
is the relative byte address of the record.
Cause. An RDF takeover operation completed successfully on the backup system.
Effect. None.
Recovery. This is an informational message; no recovery is required.
Inappropriate Message Type type
MAT position of last audit record sno rba