RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-16
RDF Messages
738
sno
is the sequence number of the TMF Master Audit Trail (MAT) for which the
synchronization point was established.
rba
is the relative byte address of the synchronization point.
Cause. The receiver has sent the extractor a starting position in the MAT, and the
extractor has thereby become synchronized with the receiver.
Effect. The extractor is synchronized with the receiver.
Recovery. This is an informational message; no recovery is required.
739
error#
is the file-system error number that identifies the specific error.
filename
is the name of the file that the updater tried to create.
Cause. An updater was unable to create a file on its UPDATEVOLUME disk.
Effect. Consult Table 5-1
to determine the effect of this error.
Recovery. Consult Table 5-1
to determine the appropriate recovery actions.
740
volume
is the name of the volume that could not be found among those protected by RDF.
Cause. This warning message is issued when a create operation for the primary
partition of a partitioned file must map one or more of the file’s secondary partitions to a
volume that does not match any of the volumes protected by RDF on the primary node.
This message is also issued when the creation of a file with alternate keys is attempted
and the corresponding alternate key file does not match any of the volumes protected by
RDF on the primary node. In either case, the create operation fails.
Extractor synch established sno rba
File Creation Failed: error# filename
Create for Unprotected RDF VOLUME Failed volume