RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-23
RDF Messages
757
Cause. The purger has detected that all the updaters have shut down following a
successful stop update to timestamp operation.
Effect. The database is now in a consistent state.
Recovery. This is an informational message; no recovery is required.
758
procname
is the name of the abending process.
Cause. The indicated process is abending.
Effect. A SAVEABEND file is created, a stack trace is logged, and the process (and its
backup process, if any) abends. RDF stops.
Recovery. If this message occurs for any process other than an updater, you will have to
resynchronize the primary and backup databases. Report this error to your service
provider.
759
Cause. An updater has encountered an audit record associated with an Enscribe
CREATE operation, an increase of MAXEXTENTS for an Enscribe file, or a
PURGEDATA operation for an Enscribe file, and the file on the primary system has
secondary partitions that are located on different systems in the network.
Effect. The updater skips this record. Note that if the record is associated with an
Enscribe CREATE operation, no partitions of the file are created on the backup system.
Therefore, if the updater subsequently encounters another audit record associated with
that file, the updater pauses its processing until that file is created.
Alternatively, if the record was associated with a PURGEDATA operation or an increase
of MAXEXTENTS, the operation is not replicated on the backup system.
Recovery. If the record is associated with an Enscribe CREATE operation, you must
manually create the file on the backup system. If the record was associated with a
PURGEDATA operation or an increase of MAXEXTENTS, you must issue a STOP
UPDATE command and then perform the operation manually on the backup system.
Stop update to timestamp operation has completed successfully
Process Abending - procname
Secondary partition on unknown node