RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-31
RDF Messages
786
Cause. The extractor has received notification of an RDFCOM STOP SYNCH
command. This event represents the start of part one of Phase 1 of the extractor’s work
in an online synchronization operation.
Effect. When the extractor encounters the next TMP control point record in the MAT, it
embarks on its Phase 1 part one processing.
Recovery. This is an informational message; no recovery is required.
787
error#
is the error number that identifies the specific error.
Cause. The receiver or an updater has encountered an error while attempting to position
within an image file.
Effect. The process abends.
Recovery. Correct the problem that caused the error and then restart RDF.
788
status
is a status code reflecting information about the error.
Cause. An RDF process received an error from the ALLOCATESEGMENT system
procedure.
Effect. This is a catastrophic error; the process abends, and RDF stops.
Recovery. Consult the description of the ALLOCATESEGMENT procedure in the
Guardian Procedure Errors and Messages Manual to determine the cause of the failure.
Once the underlying cause is corrected, you can restart RDF.
Stop synch message received
Image file position error error#
ALLOCATESEGMENT failure: returned status status