RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual522204-001
C-32
RDF Messages
789
error#
is the error number that identifies the specific error.
Cause. The primary process of an RDF process pair received an error from the
CHECKALLOCATESEGMENT system procedure.
Effect. This error is not fatal; processing continues. The backup process is stopped and
then re-created later.
Recovery. Consult the description of the CHECKALLOCATESEGMENT procedure
errors in the Guardian Procedure Errors and Messages Manual to determine the cause
of the failure. Some corrective action might be required for the backup process to be re-
created without repeated failures. The most likely cause is insufficient space available
for swapping on the swap volume.
790
cpu
is the CPU in which the backup process was created.
Cause. The backup process of a process pair was created in the specified processor.
Effect. The primary process will now run in fault-tolerant mode.
Recovery. This is an informational message; no recovery is required.
796
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause. The receiver could not create an image file due to the designated file-system
error.
Effect. This is a catastrophic error; the receiver abends and RDF stops.
Recovery. You must reinitialize the TMF and RDF subsystems.
CHECKALLOCATESEGMENT failed with error error#
Backup Process Created in Processor cpu
Image file creation error error# on filename