RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-34
RDF Messages
Recovery. For an error 12 associated with an image file, perform a FUP LISTOPENS
operation on the file to determine which process currently has the designated file open.
If that process is not an RDF process, then stop that process.
In all other cases, you must reinitialize the TMF and RDF subsystems.
799
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause. An RDF process encountered an error while attempting to read an image file.
Effect. This is a catastrophic error; the process abends, and RDF stops. The message
includes the error number returned by the READ system procedure, followed by the
name of the file that contained the error.
Recovery. If this message occurs for any process other than an updater, resynchronize
the primary and backup databases. Save the designated image file and report this error
to your service provider.
800
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause. The receiver process encountered a file-system error while attempting to write
to an image file.
Effect. The message includes the error number returned by the WRITE system
procedure followed by the image file name. For error 43 (unable to obtain disk space for
extent), the receiver retries the write operation. All other errors are fatal; the receiver
abends and RDF stops.
Image file read error error# filename
Image file write error error# filename