RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-35
RDF Messages
Recovery. The only recovery from an error 43 condition is to free some disk space.
You can do that by purging unused files, by using a FUP DEALLOCATE operation to
deallocate unused extents (not for image files), or by using DCOM to move extents so
that small free areas are combined into a larger free space.
For any condition other than error 43, you will have to resynchronize the primary and
backup databases.
801
code
is an internal error code that provides further information about the error.
Cause. An RDF process has detected an internal inconsistency.
Effect. This error should never occur and is fatal to RDF.
Recovery. Contact your service provider and report the internal error code appended to
this error message. After your service provider has appraised the situation, you will
have to resynchronize the primary and backup databases, and then reinitialize and restart
both the TMF and RDF subsystems.
802
filename
is the name of the image file associated with the error.
Cause. An RDF process has encountered a bad header in an image file.
Effect. A bad header indicates that the image file has been corrupted. This is a
catastrophic error; the process abends, and RDF stops.
Recovery. If this message occurs for any process other than an updater, you will have to
resynchronize the primary and backup databases. Save the designated image file, and
report this error to your service provider.
806
Cause. The RDFNET process has terminated normal processing as the result of a STOP
TMF or STOP RDF command."
Effect. Normal RDF shutdown processing continues.
Recovery. This is an informational message; no recovery is required.
Internal error code
Image file has bad RDF header record filename
RDF RDFNET process Shutdown Complete.