RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-36
RDF Messages
807
Cause. The operator issued a START UPDATE command.
Effect. RDF starts updating the backup database.
Recovery. This is an informational message; no recovery is required.
808
Cause. The operator issued a STOP UPDATE command.
Effect. RDF stops updating the backup database.
Recovery. This is an informational message; no recovery is required.
809
Cause. The operator issued a STOP RDF command.
Effect. The RDF process stops normally.
Recovery. This is an informational message; no recovery is required.
810
timestamp
is the time of the shutdown.
Cause. The operator issued a TMFCOM STOP TMF command at the primary node.
Effect. The RDF process stops normally.
Recovery. This is an informational message; no recovery is required.
Update mode has been set ON
Update mode has been set OFF
Shutting down in response to STOP RDF
Note. If TMF dumps any audit trail files to disk while RDF is stopped, you must either restore
the dumped files to disk or resynchronize the primary and backup databases before restarting
RDF.
Shutting down in response to STOP TMF timestamp