RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-37
RDF Messages
811
Cause. The operator issued a TAKEOVER command.
Effect. RDF starts a TAKEOVER operation.
Recovery. This is an informational message; no recovery is required.
812
error#
is the file-system error number that identifies the specific error.
procname
is the name of the process with which the updater cannot communicate.
Cause. An updater encountered a file-system error while attempting to communicate
with the receiver or purger. This message is issued by an updater.
Effect. This is a catastrophic error; the updater abends, and RDF stops.
Recovery. Determine the cause of the error. If the receiver or purger did not abend,
correct the condition, then restart RDF.
813
Cause. This message is reported by updater processes when the number of concurrent
file opens exceeds the capacity of the table in which the updater maintains information
about file opens.
Effect. The updater will close idle files (if any) and continue. If there are no idle files,
then the updater will close all files and establish a restart point from which processing
can continue. In the latter case, there will be a performance degradation.
Recovery. This is an informational message. If the condition persists, however, your
database administrator should consider moving some of the files protected by TMF on
the primary node volume to another volume, and adding another updater to back up the
new volume. If you do that, you must synchronize the affected volumes on the primary
and backup nodes.
TAKEOVER initiated
Error error# communicating with procname
Concurrent file opens exceed capacity