RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-38
RDF Messages
814
cpu#
is the number of the processor in which the backup process is now running.
Cause. The primary process has stopped for some reason, perhaps a cpu failure.
Effect. The backup process of the process pair (in the designated cpu) has taken over.
Recovery. This is an informational message, although you should determine why the
primary process stopped and take corrective action, if necessary.
815
cpu#
is the number of the processor in which the primary process is now running.
Cause. A new primary process has been created by the backup process, and the backup
process has switched control to that primary process.
Effect. The primary process of the process pair (in the designated cpu) has taken over.
Recovery. This is an informational message; no recovery is required.
816
error-num
is a file-system error number.
Cause. The specified file-system error occurred while the receiver process was
attempting to perform a setmode operation on an image trail file.
Effect. The receiver process abends.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for a
description of the file-system error. Take appropriate corrective action and then restart
RDF. If the error persists, contact your service provider.
Backup Process takeover in Processor cpu#
Primary Process takeover in Processor cpu#
Image file setmode error error-num