RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-40
RDF Messages
820
receiver
is the name of the receiver process that stopped.
Cause. The receiver has stopped unexpectedly.
Effect. This message is issued by the RDF monitor. The monitor sends an abort request
to all remaining RDF processes to stop RDF.
Recovery. A subsequent warm start of RDF might be possible, but the success of the
restart depends on the nature of the failure that caused the original process to stop.
821
updater
is the name of the updater process that stopped.
Cause. An updater has stopped unexpectedly.
Effect. This message is issued by the RDF monitor. The monitor sends an abort request
to all remaining RDF processes to stop RDF.
Recovery. A subsequent warm start of RDF will probably be successful, but the success
of the restart depends on the nature of the failure that caused the original updater process
to stop.
822
Cause. An RDF process is being shut down by the RDF monitor following the
premature loss of another RDF process.
Effect. The process stops normally.
Recovery. Scan the EMS event log to determine the original cause of the failure. It
might be possible to restart RDF.
RDF Receiver stopped unexpectedly receiver
RDF Updater stopped unexpectedly updater
Shutting down in response to ABORT RDF
Note. If TMF dumps any audit trail files to disk while RDF is stopped, you must either restore
the dumped files to disk or resynchronize the primary and backup databases before restarting
RDF.