RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-42
RDF Messages
827
Cause. The RDF process is not compatible with the audit format being generated by
TM/MP.
Effect. RDF stops.
Recovery. Restart RDF under the correct version of the operating system and/or
TM/MP.
828
Cause. The primary process of a process pair has detected a problem in communicating
with the backup process. An earlier message will have indicated the communications
problem.
Effect. Because of the severity of the problem, the primary process attempts to stop the
backup process. If the backup process stops, the primary process then attempts to create
a new backup process.
Recovery. This is an informational message; no recovery is required.
829
Cause. A mechanism other than RDF tried to run an RDF process without a name. The
monitor, extractor, receiver, purger, and all updater processes must run as named
processes within RDF.
Effect. This message is always written to $0 on the same network node as the process
being run.
Recovery. This is an informational message; no recovery is required. The message
indicates that there might have been an attempted security breach.
830
name
is the name of the RDF process that was not stopped.
Cause. The RDF monitor is attempting to stop a process on the backup node but cannot
do so because the communications lines are down.
RDF version incompatible with TM/MP
Killing backup process...
This process can only run with a name
WARNING - Net down when stopping process name