RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-48
RDF Messages
848
Cause. The extractor has sent the maximum number of messages to the receiver and has
not received any replies for at least five minutes.
Effect. The extractor cannot proceed any further.
Recovery. This is not an RDF problem. You should investigate your Expand network
and take corrective action. If necessary, you can issue an RDFCOM STOP RDF
command on both the primary and backup systems to stop the RDF processes in an
orderly fashion.
849
Cause. TMF was stopped during an RDF online database synchronization operation,
before the extractor had completed its Phase 1 processing.
Effect. The extractor abends because the database synchronization operation can no
longer succeed.
Recovery. You must reinitialize the RDF product and restart the online database
synchronization operation.
850
Cause. TMF was stopped during an RDF online database synchronization operation,
after the extractor had completed its Phase 1, Part 1 processing.
Effect. The extractor completes Phases 1 and 2 of its database synchronization
processing and then shuts down in response to the TMF shutdown audit record.
Recovery. This is an informational message; no recovery is required. When you restart
the RDF product, ensure that the duplicate database tables and files have been moved to
the backup system before you start the updaters.
Extractor waiting for network reply
TMF shutdown before Phase 1 of db synch
TMF shutdown during Phase 1 of db synch