RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-49
RDF Messages
851
Cause. The RDF product cannot support an environment where transactions involving
the RDF primary system have originated on more than 48 different nodes. The receiver
has encountered transactions that have originated on more than 48 nodes.
Effect. The receiver abends and the RDF system aborts.
Recovery. Recovery is not possible. Contact the Compaq Global Customer Support
Center (CGSC) or your service provider immediately.
852
Cause. The transaction sequence numbers being generated by TMF on the primary
system are approaching the point at which they will roll over to zero.
Effect. The receiver continues processing. If corrective action is not taken, however,
the transaction environment on the primary system could become corrupted.
Recovery. The proper corrective actions are as follows:
1. Stop the applications on the primary system.
2. Stop TMF on the primary system.
3. Wait for RDF to shut down.
4. Delete the TMF environment on the primary system.
5. Reconfigure the TMF environment on the primary system.
6. Restart TMF on the primary system.
7. Initialize RDF.
8. Retart RDF.
9. Restart the applications on the primary system.
853
Cause. In determining what transactions need to be undone, the internal table of
transaction identifiers has become filled.
Effect. RDF aborts.
Recovery. Recovery is not possible. Contact your service provider.
Too many nodes in network transactions.
Warning; transaction numbers too high
Receiver TST filled