RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-57
RDF Messages
886
Cause. The updater has reached the end of network undo takeover processing for an
RDF network environment.
Effect. The updater is ready to complete takeover processing.
Recovery. This is an informational message; no recovery is required.
887
Cause. The updater has more transactions to undo that can be undone in a single
network undo pass. Therefore it is starting an additional network undo pass.
Effect. The updater start an additional network undo pass.
Recovery. This is an informational message; no recovery is required.
888
Cause. A successful takeover has completed. If you need to bring your primary
database back into synchronization with your backup database, use file recovery on your
primary system with the specified MAT position.
Effect. None.
Recovery. This is an informational message. Consult TMF documentation for
information about file recovery to an audit trail position.
889
Cause. The purger has been attempting to build the network undo list, but is has either
encountered a network error or it has been waiting too long for information it needs.
Effect. The purger begins another attempt to build the list.
Recovery. This is an informational message. You should examine the event log to see if
the purger has reported a network error and take corrective action if required. If no
errors have been reported, then the purger is waiting for another purger in the RDF
network to complete work. If this is the case, you have no recovery action. The local
purger will retry until the remote purger has completed the required work.
Updater phase two takeover processing complete.
Commencing an additional network undo pass.
MAT position for File Recovery: SNO <num> RBA <num>.
Purger restarting on attempt to build network undo list.