RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-59
RDFCOM Messages
RDFCOM Messages
The following pages list all messages generated by RDFCOM. These messages appear
on your terminal screen during an RDFCOM session. Alternatively, they can be directed
to another output device or file through the OUT command, issued during an RDFCOM
session or the OUT parameter entered in the RDFCOM command that begins the
session. The messages appear in alphabetic order by message text.
Cause. You issued a STATUS RDF command after a TAKEOVER command has
completed, but one or more updater processes had terminated prematurely and was
therefore unable to process all applicable image audit data.
Effect. The primary and backup databases are inconsistent.
To determine which updaters terminated prematurely, examine the EMS event log for
error number 726. Then, reissue the TAKEOVER command.
Cause. You must specify the the PrimarySystem, BackupSystem,
RemoteControlSubvolume, and PnetTxVolume attributes for each Network record in the
configuration of your network master, but you are missing one or more or more of these
network attributes.
Effect. The configuration command fails.
Set the missing fields and add the record.
Cause. You must specify the PrimarySystem, BackupSystem, and
RemoteControlSubvolume for the network master of your RDF network.
Effect. The configuration command fails.
Recovery. Set the missing fields and add the record.
Cause. You tried to execute the COPYAUDIT command, but the RDF TAKEOVER
operation has not completed on the local system.
Effect. The COPYAUDIT command is aborted.
Recovery. You must execute the RDF TAKEOVER operation on both backup systems
before you can use the COPYAUDIT command of the triple contingency protocol.
A partial RDF TAKEOVER has completed
A required attribute for network master is missing
A required attribute for a non network master is missing
A TAKEOVER operation has not completed on the local system