RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual522204-001
C-60
RDFCOM Messages
error#
is the file-system error number that identifies the specific error.
volume-name
is the image trail volume on which insufficient storage exists.
Cause. During execution of a START RDF command or a VALIDATE
CONFIGURATION command, RDFCOM determined that sufficient disk storage for
image files did not exist in each secondary image trail for at least one additional image
file. As one of its validation checks during processing of these commands, RDFCOM
tries to create a temporary image file on the IMAGETRAIL volume and then attempts to
allocate all extents for it. This allocation failed for the reason indicated by the file-
system number error#.
Effect. The command fails.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for a
description of and recovery actions for the file-system error. Correct the error indicated
by error#. This might necessitate altering the IMAGETRAIL configuration
parameter to specify a new volume for the secondary image trail. Then, reenter the
START RDF or VALIDATE command.
error#
is the file-system error number that identifies the specific error.
Cause. An ALTER command failed.
Effect. The ALTER operation was not completed.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
Cause. An ALTER command was issued for a non-runtime ALTER option.
Effect. The command fails.
Recovery. Either shut down RDF and reenter the ALTER command, or select another
command to enter.
Allocation error error# on IMAGETRAIL volume-name
ALTER Failed: error#
ALTER of this element cannot be performed with RDF up