RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-62
RDFCOM Messages
Cause. You tried to add an RDF object with an ATINDEX that does not correspond to
the audit trail number of a configured auxiliary audit trail.
Effect. The ADD command fails.
Recovery. Review and revise your RDF and TMF configurations.
Cause. You tried to add an updater with the specified ATINDEX, but there is no
receiver with that value.
Effect. The ADD command fails.
Cause. No non network master NETWORK record was found when validating this
network master subsystem.
Effect. RDF does not start.
Recovery. Add one or more network records to the configuration describing the non
network master subsystem(s).
Cause. The network master network record does not have the have the specified backup
system name for the local RDF subsystem.
Effect. Validation fails.
Recovery. You must reconfigure your network master.
Cause. The RDF configuration file is invalid.
Effect. The RDF configuration record was not added.
Recovery. Enter a SET RDF command, using the BACKUPSYSTEM parameter to
identify the backup system. Then, enter an ADD RDF command to add this system to
the configuration.
Aux audit trail not found with index num
Aux RECEIVER Record does not exist for atindex num
At least one non network master NETWORK record required
Backup node in network master record is incorrect <primary-
system>
BACKUPSYSTEM is Not Defined