RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-64
RDFCOM Messages
Cause. The RDF configuration file is invalid.
Effect. The VALIDATE CONFIGURATION or START RDF command that checked
the configuration file fails.
Recovery. Check and correct the configuration file. Then reenter the VALIDATE
CONFIGURATION or START RDF command.
error#
is the file-system error number that identifies the specific error.
Cause. The context file data could not be created or cleared while START RDF
processing was being performed after the INITIALIZE RDF command.
Effect. START RDF processing is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
error#
is the file-system error number that identifies the specific error.
Cause. The configuration file data cannot be created or cleared while START RDF
processing is performed after INITIALIZE RDF.
Effect. START RDF processing is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
Configuration Validation Aborted
Couldn't create or clear the BACKUPSYSTEM CONTEXT (error#)
Couldn't create or clear the PRIMARYSYSTEM CONFIG (error#)