Manualshelf

RDF/IMP and IMPX System Management Manual (RDF 1.3+)

ManualsBrandsHP ManualsServerHP NonStop G-Series
451452453454455456457458459460
Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-71
RDFCOM Messages
Effect. The COPYAUDIT command aborts.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Take appropriate corrective action,
and then reissue the COPYAUDIT command.
error#
is the file-system error number that identifies the specific error.
Cause. The COPYAUDIT command encountered the specified error while attempting
to set the security for a new image file on the local image trail where it is storing new
audit.
Effect. The COPYAUDIT command aborts.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Take appropriate corrective action,
and then reissue the COPYAUDIT command.
error#
is the file-system error number that identifies the specific error.
Cause. The COPYAUDIT command encountered the specified error while attempting
to perform a SET MODE operation to enable large transfers of data.
Effect. The COPYAUDIT command aborts.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Take appropriate corrective action,
and then reissue the COPYAUDIT command.
Cause. The control subvolume was incorrectly specified in an OPEN command.
Effect. The command fails.
Recovery. Check the control subvolume name and make sure that you are spelling it
correctly. Then reenter the command, including the proper control subvolume name or
specifying a different control subvolume.
Error error# on setmode for imagefile security
Error error# on setmode for large transfers
Expecting: a Control Subvolume name