RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-72
RDFCOM Messages
Cause. RDF did not understand the command.
Effect. The command fails.
Recovery. Check the syntax rules for the command you entered. Perhaps you
misspelled a keyword parameter or misplaced a delimiter.
Cause. You have entered an unexpected response to an RDFCOM prompt that requires
only either YES (or Y) or NO (or N) as verification to proceed with your request.
Effect. The requested operation does not take place.
Recovery. Reenter your request, this time specifying either YES, Y, NO, or N to the
prompt.
Cause. While attempting to initialize RDF to a TMF shutdown timestamp, you have
entered an unexpected response to the RDFCOM prompt that asks if you want
RDFCOM to trigger the restoration of an audit trail file that has been dumped.
Effect. The search for the shutdown timestamp ceases, and the RDF initialization fails.
Recovery. Reenter the INITIALIZE RDF command, to begin the sequence of prompts
again. This time, respond properly (either YES, Y, NO, or N) to the prompt about
restoring the audit trail file.
error#
is the NEWPROCESS error number that identifies the specific error.
Cause. A NEWPROCESS error occurred during START RDF or TAKEOVER
processing.
Effect. The START RDF or TAKEOVER operation is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
Expecting: RDF, MONITOR, EXTRACTOR, RECEIVER, VOLUME
Expecting 'Yes' or 'No' response.
Expecting 'Yes' or 'No' response. Search stopped
Extended Data Segment Error: error#