RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual522204-001
C-73
RDFCOM Messages
error#
is the NEWPROCESS error number that identifies the specific error.
Cause. A NEWPROCESS error occurred during START RDF or TAKEOVER
processing.
Effect. The START RDF or TAKEOVER operation is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
Cause. An ADD EXTRACTOR command was issued when the configuration file
already contained an extractor record.
Effect. The command fails.
Recovery. No recovery is required if you want to use the existing extractor process as
configured. If you want to change any of the extractor’s configuration options, however,
enter an ALTER EXTRACTOR command that specifies those changes.
Cause. The INFO command could not find an extractor record in the configuration file.
Effect. The command fails.
Recovery. Alter the configuration to include an extractor process.
Cause. The COPYAUDIT command has finished copying the missing audit from the
remote system to the local system, and is now about to update context records to permit
execution of another TAKEOVER command.
Effect. RDF begins to update the context records.
Recovery. This is an informational message; no recovery is required.
Extended Swap File Segment Error: error
EXTRACTOR record exists, use ALTER EXTRACTOR
EXTRACTOR record NOT found
Fixing up context to enable another RDFCOM Takeover command