RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-82
RDFCOM Messages
Cause. You have already added the maximum number of secondary image trails (255),
and cannot add more.
Effect. The command fails.
Recovery. No recovery action is possible; your RDF subsystem can only support 256
secondary image trails.
Cause. No network record exists that corresponds to the network master subsystem.
Effect. RDF does not start.
Recovery. Add a network record to describe the network master subsystem.
Cause. An ADD MONITOR command was issued when the configuration file already
contained a monitor record.
Effect. The command fails.
Recovery. No recovery is required if you want to use the existing monitor process as
configured. If you want to change any of the monitor’s configuration options, however,
enter an ALTER MONITOR command that specifies those changes.
Cause. The INFO command could not find a monitor record in the configuration file.
Effect. The command fails.
Recovery. Alter the configuration to include the monitor process.
Cause. You have attempted to specify configuration information for an RDF network,
but you do not have an RDF/IMPX license.
Effect. The configuration command fails.
Recovery. If you need to run in an RDF network, you need to obtain the RDF/IMPX
license and product.
Maximum number of image trails already added
Missing network master NETWORK record
MONITOR Record exists, use ALTER MONITOR
MONITOR record NOT found
Network options are only available with the RDF/IMPX product