RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-83
RDFCOM Messages
Cause. An ADD NETWORK command was entered but the RDF NETWORK
parameter is set OFF.
Effect. The ADD NETWORK command is rejected.
Recovery. Reconfigure RDF to have the RDF NETWORK parameter set ON.
Cause. The current RDF subsystem is configured in an RDF network, but a network
record has not been added.
Effect. Validation fails.
Recovery. You must add the appropriate NETWORK configuration record.
Cause. An EXCLUDE pattern has been specified which will case audit associated with
the NetSynch data file to be filtered out.
Effect. RDF can not be started.
Recovery. Correct the VOLUME EXCLUDE associated with the PNETTXVOLUME
so that the EXCLUDE pattern does not exclude the file
$<volume>.<control-subvolume>.ZRDFNETX.
Cause. An INCLUDE pattern has been specified that will cause audit information
associated with the NetSynch data file to be filtered out.
Effect. RDF can not be started.
Recovery. Correct the VOLUME INCLUDE associated with the PNETTXVOLUME so
that the file $<volume>.<control-subvolume>.ZRDFNETX is included.
Cause. The RDF configuration file is invalid.
Effect. The validation fails.
Recovery. Alter the configuration to include the extractor.
NETWORK record can only be added into a networked subsystem
Network record not found
Network synch file ZRDFNETX must not be EXCLUDED
Network synch file ZRDFNETX file must be INCLUDED
No EXTRACTOR is Configured